Modern shower cubicle GRANDE TEA 80× 80 cm
The square shower cubicles are very popular because of the versatile furnishing options. A GRANDE TEA 80×80 cm shower cubicle can be installed in any suitable corner without a shower tray. In addition, your bathroom looks oven-like and fresh thanks to the clear glass. The glass panes are made of 5 mm toughened safety glass with the EasyClean coating. This surface coating easily repels the water and dirt.
Another advantage for you is the integrated revolving door system. The revolving door enables you not only to open it easily, but also to conveniently enter the shower. The associated hinges and the door handle are made of the rustproof chrome-plated stainless steel. Furthermore, the rubber seals effectively and safely prevent water from entering through the door.
The shower cubicle can be combined with a stylish shower channel flush with the floor as well as with a matching shower tray .
The installation of the shower cubicle can be carried out quickly and easily, even without specialist knowledge. The universal construction is suitable for either left or right mounting. The shower can also be set up on the floor level. The complete assembly accessories are included in the scope of delivery.
Features of the GRANDE TEA 80×80 cm shower cabin:
- Glass panes made of 5 mm safety glass (ESG) (ESG)
- EasyClean surface coating
- up to 15 mm wall compensation
- 190 cm high
- Door handle and hinges made of stainless steel, chrome-plated
- including complete mounting accessories
- Installation on the floor level is also possible
- high quality aluminum profiles
- frameless glass
Shower cubicle installation:
The installation of the corner shower cubicle can be done in a few hours. It all depends on your skills and the tools available. Those who choose to install a shower cabin on their own, but who have no experience of their own, do not need to worry. This task can also be solved without specialist knowledge.
First you need to attach the mounting profiles in the vertical position and check them with a spirit level. The distances must be measured very precisely so that the doors of the shower cubicle can close properly after installation. Mark and drill the hole positions. After that you have to insert the dowels and mount the aluminum profiles with the screws.
Insert the side parts of the shower cubicle into the mounting profiles. Then check the vertical position of the shower walls with the spirit level and fasten with the screws.
Fasten the door hinges to the side walls of the shower cubicle. Then hang the revolving doors on the hinges and screw them tight. Place the rubber seals on the doors with magnets and check that they close properly. In case the doors drag or fail to close completely, you need to fine-tune them.
Seal the edge areas of the shower cubicle to the walls and the shower tray with silicone. While pulling the trigger of the dispensing gun, guide the tip of the cartridge evenly along the joint. Then smooth the sealant smooth with a putty knife dipped in soapy water. Silicone takes about 24 hours to harden through. During this period, as far as possible, no water should get onto the joints. When the silicone seal is completely dry, you can enjoy the shower process immediately.